It is described as an “Energy Efficient Arduino UNO Compatible Design”.
“With NerO we wanted to take a whole new approach from how we normally initiated our development projects,” says Fred Dart, founder and CEO of FTDI Chip, explaining the crowdfunding approach.
NerO specification
- 16MHz ATMega328 MCU with Optiboot Bootloader
- VIN Input voltage – 7V to 20V (9V or 12V recommended)
- UNO R3 form factor
- 14 Digital I/O Pins (6 PWM outputs)
- 6 Analog Inputs
- FTDI FT231XS USB UART interface
One change from the regular Arduino is in the power supply circuit, where the LDO is replaced with a switching dc-dc converter.
As per the UNO, NerO has 14 digital interface pins plus six analogue inputs. The status and PWR LEDs are located at the edge of the PCB so they are visible when an Arduino shield has been attached.
You can see all the NerO schematics, including the 5V switching regulator design, the USB interface section and the MCU section of the design – on the Kickstarter page.
One Comment